SCE

STARFIRE™ 3000 UPDATE

Issue link: http://south88.uberflip.com/i/1420829

Contents of this Issue

Navigation

Page 1 of 3

2630 Display 1. If you are using a 2630 display with an active Modular Telematics Gateway (MTG) and in good cellular coverage, the StarFire™ 3000 receiver can be updated using Over the Air updates. NOTE: An active JDLink™ subscription is required to use the MTG cellular connection. 2. An active connection is required during this step. Download time is dependent on internet connection. 3. Once the update is downloaded, reprogramming will typically take 20 minutes for StarFire™ 3000 Receiver. 4. Select "Remote Software Updates". Available software updates will display, including the current software version and available software version for the receiver. 5. Select "Install Software". 6. Select "Accept". 7. Continue following prompts to complete installation. StarFire™ 3000 Receivers will typically take 20 minutes to complete the software update. 8. Keep the key switch in the ON or ACCESSORY position during reprogramming. Flash Drive through Display USB Port Generation 4 Display Preparing USB At Computer 1. For a Generation 4 Display, use the Software Manager Utility to download the software package to a USB. See the Generation 4 Display Software Installation Instructions on Stellar Support for details. At Machine 1. Insert your USB into the Generation 4 Display with the correct file embedded and follow the steps below to initiate the programming of the receiver. 2. Select "Software Manager". 3. Select "Install from USB Drive". 4. Select "View Updates for Other Devices". 5. Select "GPS Receiver". 6. Select correct file for programming.

Articles in this issue

view archives of SCE - STARFIRE™ 3000 UPDATE