SCE

S P R I N G S O L U T I O N S 2 0 2 5 • S O U T H C O U N T R Y. C A • O F F E R S E N D J U N E 1 5 , 2 0 2 5 24 **prices subject to change without notice** HAY MOISTURE TESTERS NUMBER DESCRIPTION PRICE 64-13800 64" Mega Roll netwrap – 13,800' of Edge to Edge with TamaTec $656.00 67-13200 67" Mega Roll netwrap – 13,200' of Cover Edge with TamaTec $633.75 64-2950 64" netwrap – 9700' of Edge to Edge with TamaTec $493.74 67-2750 67" netwrap – 9000' of Cover Edge with TamaTec $460.00 40000-B 2 – 20000' Rolls of Blue BaleBind Round Baler Twine 110lb $69.95 4730/450 4730' – John Deere Xtra Plus Yellow/Green Large Square Baler Twine 450lb $57.40 600/4100 4100' – Tama Blue Large Square Baler Twine 600lb $65.95 Netwrap and Twine sizes Today's planters require a high amount of hydraulic flow. If you have a John Deere 8R or 8RX with a single hydraulic pump, now you have the opportunity to upgrade to dual pumps. This update adds an additional 35cc pump to the standard 85cc pump and provides a total output of 84 gallons per minute (318lpm). The dual hydraulic system boasts plenty of reserve capacity to operate large hydraulic motors, even at reduced engine speeds. ■ 40% increase hydraulic flow capability ■ Uses the exact same parts used in factory installed option code ■ Reduced cab noise with the efficiency of dual pumps ■ Meets they hydraulic requirements of high-capacity planters ■ Run faster in the field or more efficiently at slow speeds NEW - Upgrade the Hydraulic Capacity on Your Upgrade your system to a dual hydraulic pump with 40% more KITS TO UPGRADE TO DUAL HYDRAULIC PUMP NUMBER DESCRIPTION APPLICATION BXX11243 Dual hydraulic pump kit Compatible with 8RW (serial NOTE: Only compatible with IVT™ transmission, with or without ILS™ system. BXX11244 Dual hydraulic pump kit Compatible with 8RW (serial Note: Only compatible with e23™ transmission, with or without ILS system. BXX11543 Dual hydraulic pump kit Compatible with 8RW (serial Note: Only compatible with IVT transmission, with or without ILS system. HARVEST TERMS TM PARTS, SERVICE, INSPECTIONS • Buy Now, Pay After Harvest 2025 • Interest Free Financing • Improved Cash Flow & Savings Scan our QR code for all current promotions and to order your parts today! Or visit shop.deere.ca HAY & FORAGE PARTS 48 This newly advanced Hay, Straw, and Silage Tester is the most efficient probe on the market. The 20" stainless steel probe and tip provides accuracy, versatility, and durability. The SW007305 will measure push force to determine whether it's a high- or low-density bale, then adjusts the moisture result for more precise accuracy. Features: • Measures 8–72% moisture content • Temperature range 32–185°F (0–85°C) • Automatic Density Compensation • Choice of hay or straw bales, separate mode for silage • Memory can store results up to 64 bales with a total of 1,000 savable moisture and temperature readings • Continuous reading as you probe bale Advanced Hay, Straw, and Silage Tester Hay Probes and Baler Mounted Testers John Deere's grain protein and moisture tester uses a lab-grade analyzer to combine portability with accuracy and ease of use before you even leave the field. It enables grain analysis by moving decision out of the lab, grain elevator, processing plants and feed mills. This tester uses Near Infra-Red Spectroscopy (NIRS) technology to determine protein, moisture, and oil. Measures a variety of grains and forage for protein, moisture, and oil. Operating temperature: 40°F–125°F (5°C–50°C) Cup unit dimensions: H: 7-in., D: 6-in. (H: 179mm, D: 152mm) Tests more than 2,000 samples on one full charge Offline mode enables testing; results available when back online (cellular service) Subscription required – not included with the price of the handheld tester NEW Handheld Grain Protein and Moister Tester NUMBER DESCRIPTION PRICE SW007305 Hay, Straw, and Silage Tester NUMBER DESCRIPTION Handheld Moisture Testers: Moisture Testers: SW16136 18-in. Probe (testing range from 14–44%) SW16326 32-in. Probe (testing range from 14–44%) Low-Moisture: SW007320 20-in. Probe (testing range from 8–44%) SW007321 10-in. Probe (testing range from 8–44%) Baler-Mounted Hay Testers: SW07350 Tester mounts inside the baler for direct readout of moisture while baling. (testing range from 8–44%) SW007360 Advanced Baler-Mounted Hay Moisture Tester (BHT-2) NUMBER DESCRIPTION SW008300 Handheld Grain Protein and Moister Tester PRICE PRICE HAY & FORAGE PARTS 48 This newly advanced Hay, Straw, and Silage Tester is the most efficient probe on the market. The 20" stainless steel probe and tip provides accuracy, versatility, and durability. The SW007305 will measure push force to determine whether it's a high- or low-density bale, then adjusts the moisture result for more precise accuracy. Features: • Measures 8–72% moisture content • Temperature range 32–185°F (0–85°C) • Automatic Density Compensation • Choice of hay or straw bales, separate mode for silage • Memory can store results up to 64 bales with a total of 1,000 savable moisture and temperature readings • Continuous reading as you probe bale Advanced Hay, Straw, and Silage Tester Hay Probes and Baler Mounted Testers John Deere's grain protein and moisture tester uses a lab-grade analyzer to combine portability with accuracy and ease of use before you even leave the field. It enables grain analysis by moving decision out of the lab, grain elevator, processing plants and feed mills. This tester uses Near Infra-Red Spectroscopy (NIRS) technology to determine protein, moisture, and oil. Measures a variety of grains and forage for protein, moisture, and oil. Operating temperature: 40°F–125°F (5°C–50°C) Cup unit dimensions: H: 7-in., D: 6-in. (H: 179mm, D: 152mm) Tests more than 2,000 samples on one full charge Offline mode enables testing; results available when back online (cellular service) Subscription required – not included with the price of the handheld tester NEW Handheld Grain Protein and Moister Tester NUMBER DESCRIPTION PRICE SW007305 Hay, Straw, and Silage Tester NUMBER DESCRIPTION Handheld Moisture Testers: Moisture Testers: SW16136 18-in. Probe (testing range from 14–44%) SW16326 32-in. Probe (testing range from 14–44%) Low-Moisture: SW007320 20-in. Probe (testing range from 8–44%) SW007321 10-in. Probe (testing range from 8–44%) Baler-Mounted Hay Testers: SW07350 Tester mounts inside the baler for direct readout of moisture while baling. (testing range from 8–44%) SW007360 Advanced Baler-Mounted Hay Moisture Tester (BHT-2) NUMBER DESCRIPTION SW008300 Handheld Grain Protein and Moister Tester PRICE PRICE $335.00 $523.74 $724.91 HAY & FORAGE PARTS This newly advanced Hay, Straw, and Silage Tester is the most efficient probe on the market. The 20" stainless steel probe and tip provides accuracy, versatility, and durability. The SW007305 will measure push force to determine whether it's a high- or low-density bale, then adjusts the moisture result for more precise accuracy. Features: • Measures 8–72% moisture content • Temperature range 32–185°F (0–85°C) • Automatic Density Compensation • Choice of hay or straw bales, separate mode for silage • Memory can store results up to 64 bales with a total of 1,000 savable moisture and temperature readings • Continuous reading as you probe bale Advanced Hay, Straw, and Silage Tester Hay Probes and Baler Mounted Testers John Deere's grain protein and moisture tester uses a lab-grade analyzer to combine portability with accuracy and ease of use before you even leave the field. It enables grain analysis by moving decision out of the lab, grain elevator, processing plants and feed mills. This tester uses Near Infra-Red Spectroscopy (NIRS) technology to determine protein, moisture, and oil. Measures a variety of grains and forage for protein, moisture, and oil. Operating temperature: 40°F–125°F (5°C–50°C) Cup unit dimensions: H: 7-in., D: 6-in. (H: 179mm, D: 152mm) Tests more than 2,000 samples on one full charge Offline mode enables testing; results available when back online (cellular service) Subscription required – not included with the price of the handheld tester NEW Handheld Grain Protein and Moister Tester NUMBER DESCRIPTION PRICE SW007305 Hay, Straw, and Silage Tester NUMBER DESCRIPTION Handheld Moisture Testers: Moisture Testers: SW16136 18-in. Probe (testing range from 14–44%) SW16326 32-in. Probe (testing range from 14–44%) Low-Moisture: SW007320 20-in. Probe (testing range from 8–44%) SW007321 10-in. Probe (testing range from 8–44%) Baler-Mounted Hay Testers: SW07350 Tester mounts inside the baler for direct readout of moisture while baling. (testing range from 8–44%) SW007360 Advanced Baler-Mounted Hay Moisture Tester (BHT-2) NUMBER DESCRIPTION SW008300 Handheld Grain Protein and Moister Tester PRICE PRICE

• Cover